Create Nas-Interface - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.2 Network Interface > create nas-interface

create nas-interface

This parameter creates a NAS network interface. In the NAS interface definition, at least one valid IP address
(the "-ip" parameter, the "-link-local-ip" parameter, or the "-connect-ip" parameter) must be specified. Up to
160 network interfaces can be created.
■ Syntax
create nas-interface [-port
vlanid
[-vlan-id
[-link-local-ip
[-connect-ip
[-ipv6-gateway
■ Parameter
-port
-rip
-vlan-id
port ] [-rip {enable|disable}]
ip_address
] [-ip -netmask
link_local_address
]
ip_address
-subnet-prefix-length
gateway_address
]
Optional. This parameter specifies the port to which the NAS interface is to be assigned.
• Only NAS ports can be specified.
• A port that is set as a member port for bonding cannot be specified.
• When VLANID is not specified, multiple NAS interface cannot be assigned to each NAS port.
• When VLANID is specified, up to 160 NAS interfaces can be assigned to each NAS port.
port
Port to which the NAS interface is assigned
Example: -port 100
Optional. This parameter specifies whether to receive routing information using the Routing
Information Protocol (RIP). The RIP supports receive processing, but does not support send
processing.
enable Routing information is received using RIP (default)
disable Routing information is not received using RIP
Optional. This parameter specifies a VLAN ID between 0 and 4094. When "0" is specified, VLAN
is disabled.
vlanid
VLAN ID (0 to 4094)
This parameter is unavailable when firmware version V10L20 is being used.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
netmask gateway_address
][-gateway
prefix_length
]
752
]
P2X0-1210-05ENZ0