Show Nas-Df - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.9 File System Maintenance > show nas-df

show nas-df

This command displays the usage status of the file system.
■
Syntax
show nas-df {-volume-number
■ Parameter
-volume-number
or
-volume-name
■ Output
Message
Volume No.
Volume Name
Total Disk Space(KB)
Used Disk Space(KB)
Available Disk Space(KB)
volume-number
This parameter specifies the target NAS TPV or NAS backup TPV. Only a single volume can be
specified.
If the specified volume does not exist or if the volumes are not NAS TPVs or NAS backup TPVs,
no items are displayed or "count 0" is displayed. In these cases, an error does not occur.
However, if the target volume does not exist when the "-volume-name" parameter is specified,
it causes an error.
volume-number
Volume number
volume-name
Volume name
Information of the file system
Volume number
Volume name
Total capacity of the file system (unit: KB)
Used capacity of the file system (unit: KB)
Available capacity of the file system (unit: KB)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
volume-name
s |-volume-name
806
}
P2X0-1210-05ENZ0