Stop Migration - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.2 Volume Management > stop migration

stop migration

This command can be used to stop the RAID migration progress if it has commenced. The migration source/
destination volumes cannot be deleted unless the RAID migration has been stopped or has completed.
This command is also used for RAID Migration in which the destination is a Flexible Tier Pool (FTRP).
■ Syntax
stop migration {-volume-number
■ Parameter
-volume-number
or
-volume-name
■
Example(s)
The following example stops the RAID migration of volume #1:
CLI> stop migration -volume-number 1
volume_numbers
This parameter specifies the migration source volume numbers or names corresponding to an
already started migration. Details can be displayed using the "show migration" command. One
or more parameters can be specified at the same time. For details, refer to
Syntax" (page 26).
volume_numbers
Volume number
volume_names
Volume name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
volume_names
| -volume-name
137
}
"1.2.10 Volume
P2X0-1210-05ENZ0