Delete Host-Sense - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > delete host-sense

delete host-sense

This command deletes (clears) the specified host sense.
■
Syntax
delete host-sense
{-host-response-number
-sense-number
■ Parameter
-host-response-number
or
-host-response-name
-sense-number
■
Example(s)
The following example respectively deletes the host sense #1 corresponding to the host response #1 to #3:
CLI> delete host-sense -host-response-number 1-3 -sense-number 1
host_response_numbers
sense_numbers
This parameter specifies host response identifiers to which the host sense to be deleted
belongs. The range is 1 to 200. One or more parameters can be specified at the same time. For
details, refer to "1.2.13 Host Response Syntax" (page
host_response_numbers
Host response number
host_response_names
Host response name
This parameter specifies the host sense number that is to be deleted. The host sense number is
automatically registered in the system when the host sense conversion information is created.
Between 1 to 8 can be specified. The host sense number can be checked by using the "show
host-sense" command. One or more parameters can be specified at the same time.
sense_numbers
Host sense number (1 – 8)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| -host-response-name
28).
362
host_response_names
}
P2X0-1210-05ENZ0