Volume Syntax - Fujitsu Eternus DX100 S3 User Manual

Chapter 1 Overview
1.2 The Command Syntax
• RAID group name
A RAID group name must be specified when creating a RAID group. For details about the syntax, refer to
"1.2.5 Alias Name Syntax" (page
names. A RAID group name and a RAID group number cannot both be specified in the same command. Do
not include spaces before or after commas (,).
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
1.2.10

Volume Syntax

There are two methods to specify a volume identifier; a volume number or a volume name.
• Volume number
A volume number is automatically created by the system when a volume is created. This is a decimal
number. Volume numbers can be displayed by using the "show volumes" command.
Volume numbers may be combined as follows:
- A volume number: 1
- A list of volume numbers: 5,10
- A hyphenated range of volume numbers from
- A list of volume numbers, volume ranges, or both, separated by commas (,). Spaces are not permitted
before or after commas (,): 1,3,10-12
• Volume name
A volume name with "$SYSVOL" as a prefix cannot be specified when a volume is created or renamed.
To specify a volume name, use the volume name that is set when the volume is created. Note that this
does not apply when a volume is created or renamed.
For details about the syntax, refer to
comma-separated list of volume names. A volume name and a volume number cannot both be specified in
the same command unless a volume is created or renamed. Do not include spaces before or after commas
(,).
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
23). Some commands accept a comma-separated list of RAID group
a
to z: 2-5
"1.2.5 Alias Name Syntax" (page
26
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
23). Some commands accept a
P2X0-1210-05ENZ0