Fujitsu Eternus DX100 S3 User Manual page 656

Chapter 6 Information Settings and Display
6.1 Performance > show performance
-cm
-port
■
Output
Status
Interval
Volume
IOPS(IOPS) IOPS
Throughput
Optional. This parameter specifies the controller module number. This parameter can be
specified only when "-type cm" is selected. If omitted, the information for both controller
modules is listed.
0 Controller module #0
1 Controller module #1
Optional. This parameter specifies the host interface port number, and can be specified only
when selecting "-type port". Only one parameter can be specified at the same time. If omitted,
all the host interface ports are displayed.
Example: -port 001
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host
port number.
Example: "123" indicates CM#1-CA#2-Port#3
Indicates whether collection of performance information has started
The interval time by which performance information is updated
Volume identifiers
No. Volume number
Name Volume name
Read Read IOPS
Write Write IOPS
Transmitted Transmitted IOPS
Received Received IOPS
Throughput (in MB/s)
Read Read throughput
Write Write throughput
Transmitted Transmitted throughput
Received Received throughput
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
656
29).
P2X0-1210-05ENZ0