Fujitsu Eternus DX100 S3 User Manual page 254

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fcoe-parameters
-host-response-number
or
-host-response-name
-reset-scope Optional. This parameter specifies the range of reset action. If omitted, the existing setting is
-reserve-cancel
-fcf-vlan-id
-fcf-vlan-id-value
-fcf-fabric-name
-fcf-fabric-name-value
Optional. This parameter specifies a host response identifier. Only one host response identifier
can be specified at the same time. If omitted, the existing setting is not changed. For details,
refer to "1.2.13 Host Response Syntax" (page
host_response_number
Host response number
host_response_name
Host response name
not changed.
initiator-lun Reset (Cancel) the command request from the server that sent the command
reset request.
target-lun Reset (Cancel) the command request from all servers that are connected to the
port (regardless of whether the LUN is recognized).
Optional. This parameter specifies whether or not SCSI reservation (persistent reservation) is
canceled when host interface ports are reset. If omitted, the existing setting is not changed. If
the RA mode is set for the specified port, this parameter cannot be specified.
enable Reservations are canceled.
disable Reservations are not canceled.
Optional. This parameter specifies the FCF VLAN ID setting disable or enable. To set "enable",
the "-fcf-vlan-id_value" parameter must be set.
enable FCF VLAN ID manual setting.
disable FCF VLAN ID auto setting
Optional. This parameter specifies the FCF VLAN ID for connection to FCF (FCoE switch). This
parameter must be set to set "-fcf-vlan-id" to "enable".
0 – 4095 FCF VLAN ID
Optional. This parameter specifies the FCF Fabric Name (WWN) setting disable or enable. To
set "enable", the "-fcf-fabric-name-value" parameter must be set.
enable Connection check for FCF using FCF Fabric Name (WWN).
disable Connection check nothing.
Optional. This parameter specifies the FCF Fabric Name for connect check to FCF (FCoE switch).
This parameter must be set to set "-fcf-fabric-name" to "enable".
WWN
WWN value (8 byte)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
28).
254
P2X0-1210-05ENZ0