Fujitsu Eternus DX100 S3 User Manual page 355

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-response
-monitor-time
-load-balance-rsp-status
-iscsi-disc-rsp
-iscsi-rsv-range
■
Example(s)
The following example sets up the host response for host response #1. The new host response name is "win-
x". The response status is Busy status. The host command timeout is 30 seconds:
CLI> set host-response -host-response-number 1 -name win-x -load-balance-rsp-status busy -monitor-time 30
Optional. This parameter specifies the timeout value of a host command. The range of the val-
ues is 10 – 255 and the unit for timeout is in seconds. If this parameter is omitted, the existing
setting remains unchanged. The default value is 25 seconds.
monitor_time
Timeout value of a host command (10 – 255)
Optional. This parameter specifies the response status responded to host servers. If this
parameter is omitted, the existing setting remains unchanged.
busy Busy status is responded to host servers.
queue-full Queue-Full status is responded to host servers.
unit-attention
Unit-Attention status is responded to host servers. (default)
Optional. This parameter specifies the reply mode for the iSCSI Discovery request.
all Replies to the server with the information for all the iSCSI ports (iSCSI names and
IP addresses).
port Replies to the server with only the information for the specified iSCSI ports (iSCSI
names and IP addresses).
Optional. This parameter specifies the reservation management range for iSCSI connections.
port Each CA port
system Each storage system (Default)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
355
P2X0-1210-05ENZ0