Set Advanced-Copy-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management > set advanced-copy-parameters

set advanced-copy-parameters

This command sets up parameters to use the Advanced Copy functions.
■
Syntax
set advanced-copy-parameters [-resolution {1|2|4|8|16|32|64}] [-table-size
[-sdpe {1g|2g|4g}] [-ec-opc-priority {auto|very-low|low|middle|high}] [-warning
[-copy-schedule-mode {session-balancing|dst-rg-balancing}]
■ Parameter
-resolution
-table-size
-sdpe
Optional. This parameter specifies the Advanced Copy resolution. The default value for the
ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX200F is "16", and "1" for the ETERNUS DX500
S3/DX600 S3. If omitted, the existing setting is not changed.
1
1
2
2
4
4
8
8
16
16
32
32
64
64
Optional. This parameter specifies the Advanced Copy table size. The size can be specified in
multiples of 8MB. Note that the maximum value depends on the memory size that is to be
installed in the controllers. The initial value is set to 128MB for the ETERNUS DX100 S3/DX200
S3 and the ETERNUS DX200F, and 0MB for the ETERNUS DX500 S3/DX600 S3. If omitted, the
existing setting is not changed.
The maximum Advanced Copy table size for each model are shown below:
ETERNUS DX100 S3/DX200 S3: 0 to 512MB
ETERNUS DX500 S3: 0 to 1024MB
ETERNUS DX600 S3: 0 to 4096MB
ETERNUS DX200F: 0 to 512MB
table_size
Advanced Copy table size
Optional. This parameter specifies the resolution for the SDPV. The initial value is set to 1GB. If
omitted, the existing setting is not changed.
1g 1GB (default)
2g 2GB
4g 4GB
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
406
table_size
]
warning_level
]
P2X0-1210-05ENZ0