Fujitsu Eternus DX100 S3 User Manual page 861

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
EBF00
EBF01
EBF02
EBF03
EBF04
EBF05
EBF06
EBF07
EBF0A
EBF0B
EBF0C
EBF0D
EBF0E
EBF10
EBF11
EBF12
EBF13
EBF15
EBF16
ED000
The number of registered TFO group has exceeded maximum in this device.
The number of registered TFO groups has exceeded the maximum number set in this device.
TFO Group is exist.
TFO Groups exist.
TFO group does not exist.
TFO groups do not exist.
The specified TFO group name is already registered.
The specified TFO group name has already been registered.
The specified CA Port is not in the specified TFO group.
The target port is not included in the specified TFO group.
The specified TFO group is primary.
The TFO group that is specified is the primary.
The specified port is not TFO port.
The specified port is not a TFO port.
The specified port is already TFO pair port configured.
The specified port is already configured in the TFO pair port.
The specified volume is not in process of TFO pair.
The TFO pair does not exist in the specified volume.
The TFO group is primary.
The command was executed on the primary TFO group.
The specified volume is in process of TFO pair.
The TFO pair is configured in the specified volume.
There is a volume what is in process of TFO pair.
The volume that has been configured with the TFO pair exists in the specified pool.
The specified volume is configured TFOV.
The specified volume is configured as the TFOV.
Change of size was specified volume is TFOV.
Changing the size was specified by the TFOV.
The parameter needs storage cluster license.
The Storage Cluster license is not registered. The specified parameter cannot be used.
The destination port belongs to TFO group.
The copy destination port belongs to the TFO Group.
The source port belongs to TFO group.
The copy source port belongs to the TFO Group.
The specified port has been changed WWPN/WWNN.
The WWPN/WWNN of the specified port has been changed.
TFO group is set to manual failover.
For the TFO group that is configured to manual failover, the monitoring interval is specified until the
failover completes.
Send failed internal command.
An internal error has occurred. If this error persists, request your maintenance engineer to investigate the
error.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
861
P2X0-1210-05ENZ0