Create Role - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.1 User Management > create role

create role

This command creates a new user-defined role to which any policy is assigned. Multiple policies can be
assigned to one role. Role names that are already registered cannot be used to create new roles.
■ Syntax
create role -name
■ Parameter
-name
-policy
name policy
-policy
This parameter specifies a unique name for the new role. Usable characters are alphanumeric
(case-sensitive), exclamation mark (!), hyphen (-), underscore (_), and dot (.) characters. A
minimum of 1 letter and a maximum of 16 letters are required.
name
Name for the new role
This parameter specifies the policies that are assigned to the role. Use the numbers that are
listed below to specify policies. Multiple policies can be specified by separating them with a
comma (,) or a hyphen (-). Note that spaces are not permitted before or after commas (,).
policy Policy that is assigned to the role
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Status Display
RAID Group Management
Volume - Create/Modify
Volume - Delete/Format
Host Interface Management
Advanced Copy Management
Copy Session Management
Storage Migration Management
Resource Domain Management (not supported)
Storage Management
User Management
Authentication/Role
Security Setting
Audit Setting (not supported)
Maintenance Information
Maintenance Operation
Software Control (not supported)
Firmware Management
NAS Management
469
P2X0-1210-05ENZ0