Fujitsu Eternus DX100 S3 User Manual page 352

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-response
-name
-lun-address
-lun-expand-mode
-symmetric
-tpgs
host_response_number
Host response number
host_response_name
Host response name
Optional. This parameter specifies the host response name for this host response identifier. If
this parameter is omitted, the existing setting remains unchanged. This parameter cannot be
specified for host response #0. For details, refer to
This parameter is required when initially defining a host response.
name
Host response name
Optional. This parameter specifies the format for LUN addressing. If this parameter is omitted,
the existing setting remains unchanged.
prhl-dev The Peripheral Device Addressing mode is set. (Default)
The range for LUN mapping that this mode can reference is specified by the "-
lun-expand-mode" parameter.
flat-space The Flat Space Addressing mode is set.
With this mode, up to 4096 LUNs can be referenced for LUN mapping.
Optional. This parameter specifies whether the range of LUN mapping reference is expanded
to 4096 when "prhl-dev" is specified for the "-lun-address" parameter. When "flat-space" is
specified for the "-lun-address" parameter, this parameter cannot be specified. If this
parameter is omitted, the existing setting remains unchanged.
enable The range of the LUN mapping reference is set to 4096.
disable The range of the LUN mapping reference is set to 256. (default)
Optional. This parameter specifies the method that is used to access a Logical Unit. If omitted,
the existing setting is not changed.
active ACTIVE/ACTIVE
passive ACTIVE-ACTIVE/PREFERRED-PATH (Default)
Optional. This parameter specifies whether to enable Target Port Group Support (TPGS).
enable TPGS is enabled (default).
disable TPGS is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"1.2.5 Alias Name Syntax" (page
352
23).
P2X0-1210-05ENZ0