Fujitsu Eternus DX100 S3 User Manual page 840

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5084
E5100
E5101
E5102
E5104
E5105
E5106
E5107
E5108
E5109
E5110
E5200
E5201
E5202
E5203
E5204
E5205
E5206
E5207
System not ready.
The status of the ETERNUS DX is "Not Ready".
Thin Provisioning mode is invalid.
The Thin Provisioning function is disabled.
Check thin-pro-pool Status.
The Thin Provisioning Pool cannot be formatted. Check the status of the Thin Provisioning Pool by using
the "show thin-pro-pools" command.
Migration session count is limit.
The number of sessions (including balancing sessions) has reached the maximum number of sessions
that can run in an ETERNUS DX.
Thin Provisioning Pool capacity is limit.
The TPP capacity exceeds the maximum TPP capacity that can be created in an ETERNUS DX.
Not exist unused disk enough
The number of unused disks is insufficient.
RAID or Volume is insufficient.
The number of RLUs, DLUs, or SLUs is insufficient.
RAID type is temporary.
The RAID group is temporarily being used.
Volume type is not Thin Provisioning Volume.
The volume type is not TPV (TPPC).
RAID group belong to thin-provisioning-pool/flexible-tier-pool.
The RAID group belongs to a Thin Provisioning Pool or a Flexible Tier Pool.
Thin Provisioning Volume count is limit.
The maximum number of volumes has been registered in the ETERNUS DX.
No copy license.
No copy license is registered.
Invalid copy phase
The current phase of the copy session is incorrect. Check the session phase by using the "show advanced-
copy-sessions" command.
Exist SDV / SDPV.
SDVs or SDPVs exist.
Exist REC disk buffer.
REC disk buffer volumes exist.
Exist REC buffer.
The REC buffer is set.
Exist REC path setting.
The REC path is set.
Exist any of copy session(s).
Copy sessions exist. Check the sessions by using the "show advanced-copy-sessions" command. Wait until
the copy sessions finish, and then try again.
Exist volume(s) of protection from copy destination.
Copy destination volumes with protection settings exist.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
840
P2X0-1210-05ENZ0