Fujitsu Eternus DX100 S3 User Manual page 417

Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management > show advanced-copy-sessions
Destination Volume
Status
Phase
Error Code
Requestor
When details are displayed:
SID, Generation, Type, Volume Type, Source Volume, Destination Volume, Status, Phase, Error Code,
and Requestor
Source Block Address (LBA)
Destination Block Address (LBA)
Total Data Size(MB)
Copied Data Size(MB)
Modified Data Size(MB)
SDP Used Capacity(MB)
SDP-ID (assigned to SDV)
Direction
Sync
Copy destination volume identifiers (This information is displayed when types other
than Monitor are selected.)
No. Copy destination volume number
Name Copy destination volume name
Session status (Idle, Reserve, Active, Error Suspend, Suspend, or Halt)
The session phase (No Pair, Copying, Equivalent, Tracking, Tracking&Copying, or
Readying) is displayed when EC, QuickOPC, Monitor, or REC is selected.
Error code (for details, refer to
hexadecimal number
Requestor that started the session (GUI, CLI, SMI-S, SCSI or LAN)
Refer to the above information when a list is displayed.
The copy source Start Logical Block Address (LBA) in the specified range is displayed in
16-digit hexadecimal.
The copy destination Start LBA in the specified range is displayed in 16-digit
hexadecimal.
Total data size
Copied data size
Tracking data size
Used Snap Data Pool capacity is displayed when the type SnapOPC or SnapOPC+ is
selected.
Snap Data Pool ID that is assigned to SDV is displayed when the type SnapOPC or
SnapOPC+ is selected.
In the relevant copy session, the direction of the copy is displayed when the type REC is
selected (Primary: copy source, Secondary: copy destination).
Operation mode of the session is displayed. Details are as follows:
Sync: Synchronous Operation Mode
Async: Asynchronous Operation Mode
417
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"A.2.1 Copy Session Error Codes" (page 881).) in a 2-digit
P2X0-1210-05ENZ0