Show Host-Lu-Qos-Performance - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-performance

show host-lu-qos-performance

This command displays the Host-LU QoS performance measurement information for each port, host, and LUN.
To display this information, CLI or GUI must be used to obtain this information.
■ Syntax
show host-lu-qos-performance [-port
■ Parameter
-port
-host-number
or
-host-name
■ Output
When all of the parameters are omitted:
Port
IOPS
xyz
Optional. This parameter specifies the port and the LUN or host that are associated with the
port for which the Host-LU QoS performance measurement information is to be displayed.
Multiple ports cannot be specified.
Example: -port 000,100
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the port
number.
Example: "123" indicates CM#1-CA#2-Port#3
Optional. This parameter specifies the host or the LUNs that are associated with the host for
which the Host-LU QoS performance measurement information is to be displayed. The "-port"
parameter must be set to use this parameter. Multiple hosts cannot be specified. For details,
refer to "1.2.11 Host Syntax" (page
host_number
Host number
host_name
Host name
Port number
Number of I/Os per second for a port
Ave Average number of I/Os per second for a port
Min Minimum number of I/Os per second for a port
Max Maximum number of I/Os per second for a port
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_number
[-host-number
27).
336
host_name
| -host-name ]]
29).
P2X0-1210-05ENZ0