Fujitsu Eternus DX100 S3 User Manual page 553

Chapter 5 System Settings and Display
5.2 Network Management > set email-notification
■ Example(s)
The following example sets up the parameters of the SMTP server. The Ethernet port is the Maintenance port
(MNT port), the SMTP server is "foo1.bar1", and the authentication method is "CRAM-MD5". The user name
for SMTP authentication is "profile1", the SMTP port number is the default, an e-mail sender address is
"foo2@bar2", and the e-mail receiver address is "foo@bar". The SMTP over SSL function is used with the SSL/
TLS method. The port number is 465. The fixed message is the following:
test-line 1
test-line 2
CLI> set email-notification -send enable -port maintenance -server foo1.bar1 -authentication cram-md5 -
smtp-over-ssl ssl-tls -port-number 465 -user profile1 -from foo2@bar2 -to1 foo@bar -text-count 2 -text1
"test-line 1" -text2 "test-line 2"
Password :
The following example sets up the parameters of the SMTP server. The Ethernet port is remote port (RMT
port), SMTP server is "buz.varx". E-mails sent that are larger than 128KB are divided into 128KB parts, other
options are not set, and default values are used:
CLI> set email-notification -send enable -port remote -server buz.varx -partial-mode enable -partial-size
128kb
553
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0