Show Fru-Ce - Fujitsu Eternus DX100 S3 User Manual

Chapter 2 Status Display
2.1 Storage System Status > show fru-ce

show fru-ce

This command displays the status of components (Field Replaceable Units) of the controller enclosure.
■
Syntax
show fru-ce [-type {cm0|cm1|psu0|psu1}]
■ Parameter
-type
■ Output
The following table shows the output information when the controller module and the sub-components are
specified:
CM#n Information (n: The controller module number)
CPU Status/Status Code
Memory Size
Parts Number
Serial Number
Hardware Revision
CPU Clock
CM Active EC
CM Next EC
Optional. This parameter specifies the target component (FRU) name. The details and status of
each component embedded in the controller enclosure will be displayed. Only one parameter
can be specified. If this parameter is omitted, all of the FRUs are displayed.
cm0 Details and status of the Controller Module Unit #0 and the sub-components
cm1 Details and status of the Controller Module Unit #1 and the sub-components
psu0 Details and status of the Power Supply Unit #0
psu1 Details and status of the Power Supply Unit #1
Controller Module (CM#n) status and the status code
Memory size of a controller module
Parts number
Serial number
Hardware version
CPU clock frequency
EC number of the active firmware (The current operating firmware)
EC number of the stand-by firmware (The generation number of the firmware after the
next power cycle)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
46
P2X0-1210-05ENZ0