Appendix A Error Messages/Error Codes
A.2 Error Codes
A.2
Error Codes
Ths section explains error codes.
A.2.1
Copy Session Error Codes
Table 1.2
List of copy session error codes
Error code
–
0x10
0x1F
–
0x20
0x2F
–
0x30
0x3F
0xBA
0xBB
0xBD
0xBE
0xBF
Error codes other than above
An error that is caused by a copy source volume occurs. Some copy source volumes can-
not be accessed because a failure has occurred in a component (e.g. drives and drive
enclosures).
An error that is caused by a copy destination volume occurs. Some copy destination vol-
umes cannot be accessed because a failure has occurred in a component (e.g. drives
and drive enclosures).
An error occurred due to a copy path or an REC buffer HALT occurred.
Bad data exists.
SDV/SDP capacity is insufficient.
Overload status is detected in a copy destination volume or a copy destination storage
system.
A copy path has failed. Data is stored in the REC Buffer. This error is displayed only
when the "Type" is "REC".
A copy path has failed. Data is stored in the REC Disk Buffer. This error is displayed only
when the "Type" is "REC".
An error other than the ones listed above occurs.
881
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Description
P2X0-1210-05ENZ0