Fujitsu Eternus DX100 S3 User Manual page 497

Chapter 5 System Settings and Display
5.2 Network Management > set network
-master-link-local-ip
-slave-link-local-ip
-master-connect-ip
-slave-connect-ip
Optional. This parameter specifies the link local IP address of the master IP. If omitted, the
existing setting is not changed. This parameter can only be specified when "v6" is specified for
the "-ip-format" parameter and "disable" is specified for the "-ipv6-set-auto" parameter.
Example: -master-link-local-ip fe80::9abd:2df
• When "0" is set, the IPv6 settings for the port are disabled.
• When both IPv4 and IPv6 settings are disabled, the port becomes unavailable. (This does not
apply to the ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX200F. Both the maintenance
port and the remote port must be enabled for the ETERNUS DX500 S3/DX600 S3.)
ip_address
Link local IP address of the master IP
Optional. This parameter specifies the link local IP address of the slave IP. If omitted, the
existing setting is not changed. This parameter can only be specified when "v6" is specified for
the "-ip-format" parameter and "disable" is specified for the "-ipv6-set-auto" parameter.
Example: -slave-link-local-ip fe80::9ab0:2d0
ip_address Link local IP address of the slave IP
Optional. This parameter specifies the connect IP address of the master IP. Global unicast
addresses (including 6to4 addresses) and unique local unicast addresses can be specified for
the connect IP address. If omitted, the existing setting is not changed. This parameter can only
be specified when "v6" is specified for the "-ip-format" parameter and "disable" is specified for
the "-ipv6-set-auto" parameter.
Example: -master-connect-ip 2003:12b:84d::87:3e3
ip_address
Connect IP address of the master IP
Optional. This parameter specifies the connect IP address of the slave IP. Global unicast
addresses (including 6to4 addresses) and unique local unicast addresses can be specified for
the connect IP address. If omitted, the existing setting is not changed. This parameter can only
be specified when "v6" is specified for the "-ip-format" parameter and "disable" is specified for
the "-ipv6-set-auto" parameter.
Example: -slave-connect-ip 2003:120:84d::7ac:45
ip_address
Connect IP address of the slave IP
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
497
P2X0-1210-05ENZ0