Fujitsu Eternus DX100 S3 User Manual page 122

Chapter 3 Configuration Settings and Display
3.2 Volume Management > create volume
-count
-copy-protection
-attention
-encryption Optional. This parameter specifies whether the encryption by a CM is performed. When
-wide-stripe-size
Optional. This parameter specifies the number of volumes to be created. If omitted, a single
volume is created with the name determined by the "-name" parameter. Requesting two or
more volumes results in the creation of volumes with names determined by the "-name"
parameter with a trailing index number, starting from "0".
Only "1" can be specified when "-concatenation-order manual" is specified.
Example: For "-count 3 -name abc", the volumes named "abc0", "abc1", and "abc2" are created.
If these volumes already exist, the names of the created volumes use incrementing index
numbers.
Only "1" can be specified when "-type nas-tpv" or "-type nas-tpv-backup" is specified.
count
Number of volumes
Optional. This parameter protects a volume from being specified for the copy destination. It is
possible to set it even when there is already a copy session. The copy license is necessary for
this setting. If this parameter is omitted, "disable" is set.
enable Volume is protected at the copy destination.
disable Volume is not protected at the copy destination.
Optional. This parameter specifies the attention level of the Thin Provisioning Volume (TPV).
This parameter can be specified when the "-type tpv" parameter, the "-type nas-tpv"
parameter, or the "-type nas-tpv-backup" parameter is specified. The settable range is 1 –
100%. If this parameter is omitted, the default value (80%) is set.
attention
Attention level of the Thin Provisioning Volume (TPV)
"enable" is selected, the specified volume data is encrypted. If this parameter is omitted,
"disable" is set. This parameter cannot be specified when the "-type tpv" parameter, the "-type
nas-tpv" parameter, or the "-type nas-tpv-backup" parameter is specified.
enable The volume data is encrypted.
disable The volume data is not encrypted.
Optional. This parameter specifies the Wide Stripe Size for the Wide Striping Volume that is to
be created. This parameter can only be specified when the "-type wsv" parameter is set. If
omitted, then it is handled as if "normal" is selected.
normal The Wide Stripe Size for the Wide Striping Volume is set to 16MB.
small The Wide Stripe Size for the Wide Striping Volume is set to 2MB. Note that if
the Stripe Size of the RAID group exceeds 2MB, the actual Stripe Size of the
RAID group is used for the WSV that is to be created.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
122
P2X0-1210-05ENZ0