Set Sed-Key-Server - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.3 System Settings > set sed-key-server

set sed-key-server

This command sets up the key servers. Up to two key servers can be registered.
■
Syntax
set sed-key-server -server-id
[-port {maintenance | remote}]
■ Parameter
-server-id
-server
-port-number
-port
■
Example(s)
The following example sets up the key server:
CLI> set sed-key-server -server-id 1 -server 10.21.134.198 -port-number 5696 -port maintenance
server_id
[-server {
This parameter specifies the key server ID that is to be registered. 1 or 2 can be specified.
server_id Key server ID
Optional. This parameter specifies the key server. Only one server can be specified. The server
name format should be IPv4 standard notation (a base 256 "d.d.d.d" string), IPv6 address
format, or a fully qualified domain name (FQDN). Up to 63 alphanumeric characters can be
specified. Specify a null character ("") to disable the specified server ID. If omitted, the existing
setting is not changed.
Example: -server 192.168.1.20
Example: -server fd80::abd0:223:ad
Example: -server foo.bar
server Key server
"" The specified server ID is disabled.
Optional. This parameter specifies the port number of the key server. Specify the port number
within 1 to 5 digits. The port number cannot be set above 65535. If omitted, the setting is not
changed. The default value is 5696.
port_number
Port number of the key server
Optional. This parameter specifies the LAN port for the key server. If omitted, the existing
setting is not changed.
maintenance
MNT port
remote RMT port
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
server
| ""}] [-port-number
640
port_number
]
P2X0-1210-05ENZ0