Fujitsu Eternus DX100 S3 User Manual page 340

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-performance
Delay Time(ms)
When the port number and the host are specified (the host affinity mode is enabled):
x
CM#
Port Type
Host Affinity
Performance Monitoring
Monitoring Start Time
Monitoring Stop Time
Host No.
Host Name
WWN
SAS Address Host SAS address (when the port type is SAS)
iSCSI Name Host iSCSI name (when the port type is iSCSI)
IP Address
IOPS
Delay time (in milliseconds)
Total Accumulated delay time for the start of a command due to the QoS control
of a LUN.
"Overflow" is displayed when a long time passes from the start of
performance measurement to the end of performance measurement and
the accumulated delay time exceeds the limit.
Ave Average delay time for a single command due to the QoS control of a LUN
y z
CA# Port#
Host interface port number
Port type
Host affinity (Enable: enabled, Disable: disabled)
Measurement status (ON: performance is being measured, OFF: performance
measuring is stopped)
Performance measurement start time
Performance measurement stop time
Host number
Host name
Host WWN (when the port type is FC or FCoE)
Host IP address (when the port type is iSCSI)
Number of I/Os per second for a host
Ave Average number of I/Os per second for a host
Min Minimum number of I/Os per second for a host
Max Maximum number of I/Os per second for a host
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
340
P2X0-1210-05ENZ0