Fujitsu Eternus DX100 S3 User Manual page 3

This manual describes how to use the Command Line Interface (CLI) to configure and manage the FUJITSU
Storage ETERNUS DX100 S3/DX200 S3 Disk storage system, the FUJITSU Storage ETERNUS DX500 S3/DX600 S3
Disk storage system, or the FUJITSU Storage ETERNUS DX200 All Flash Array (hereinafter referred to as
ETERNUS DX).
This manual is written for standard-level users who are familiar with the basic functions of the ETERNUS DX.
This manual is written for controller firmware version V10L20 or later. Some of the functions and operations
herein may not be supported for firmware version V10L1x or earlier.
Content and Structure
This manual contains the following eight chapters and appendices:
●
Chapter 1 Overview
This chapter introduces the ETERNUS DX Command Line Interface (CLI).
●
Chapter 2 Status Display
This chapter explains the commands used for displaying the status details for the ETERNUS DX as a whole,
as well as for various ETERNUS DX components.
●
Chapter 3 Configuration Settings and Display
This chapter explains the commands used for Thin Provisioning management, RAID group management,
volume management, and host interface management, these being the basic settings for the ETERNUS
DX.
●
Chapter 4 Copy Function Settings and Display
This chapter explains the commands used for Advanced Copy management.
●
Chapter 5 System Settings and Display
This chapter explains the commands used for user account management, network management
(Redundant IP/SNMP etc.), date and time/NTP, system configuration (Box ID, Storage system name), power
synchronization, and SSH/SSL security configuration.
●
Chapter 6 Information Settings and Display
This chapter explains the commands used to provide performance data and a variety of other information.
3
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Preface
Fifth Edition
June 2014
P2X0-1210-05ENZ0