Set Sas-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set sas-parameters

set sas-parameters

This command sets up the parameters of each SAS interface port. It can also be used to change Host Affinity
Mode.
■ Syntax
set sas-parameters -port {
[-host-response-number
[-reset-scope {initiator-lun | target-lun}] [-reserve-cancel {enable | disable}]
■
Parameter
-port
-host-affinity
-rate
-host-response-number
or
-host-response-name
xyz
|all} [-host-affinity {enable | disable}] [-rate {auto | 1.5g | 3g | 6g}]
host_response_number
This parameter specifies which SAS interface port is to be set.
Example: -port 000
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the SAS port
number.
Example: 110 (CM#1 ,CA1 , SAS port#0)
all All SAS interface ports
Optional. This parameter specifies Host Affinity Mode. If omitted, the existing setting is not
changed. Host affinity is a security mechanism used to restrict access by a given host to only a
specific set of LUNs.
enable Host Affinity Mode is enabled.
disable Host Affinity Mode is disabled.
Optional. This parameter specifies the SAS transfer rate. If omitted, the existing setting is not
changed.
auto Auto negotiation
1.5g 1.5Gbit/s
3g 3Gbit/s
6g 6Gbit/s
Optional. This parameter specifies the host response identifier. Only one identifier can be
specified at any given time. If omitted, the existing setting is not changed. For details, refer to
"1.2.13 Host Response Syntax" (page
-host-response-number
Host response number
-host-response-name
Host response name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| -host-response-name
28).
232
host_response_name ]
29).
P2X0-1210-05ENZ0