Fujitsu Eternus DX100 S3 User Manual page 248

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-rec-transfer-stack
-rec-transfer-consistency
-rec-transfer-through
-tfo-transfer-mode
■
Example(s)
The following example disables Host Affinity Mode for iSCSI interface port#0 on CM#1 CA#0:
CLI> set iscsi-parameters -port 100 -host-affinity disable
The following example sets "192.168.1.1" for the IP address, "255.255.255.0" for the subnet mask, and
"user01" for the CHAP user name of iSCSI interface port#1 on CM#0 CA#1:
CLI> set iscsi-parameters -port 001 -ip 192.168.1.1 -netmask 255.255.255.0 -chap-user user01
Password :
Confirm Password :
Optional. This parameter specifies the asynchronous stack mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can only be specified for the ports
that both of the following conditions apply to: the Advanced Copy license has been registered
and the port mode is RA mode or CA/RA auto mode.
enable An REC in asynchronous stack mode is permitted for the target CA port.
disable An REC in asynchronous stack mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous consistency mode for the copy transfer
mode. If omitted, the existing setting is not changed. This parameter can only be specified for
the ports that both of the following conditions apply to: the Advanced Copy license has been
registered and the port mode is RA mode or CA/RA auto mode.
enable An REC in asynchronous consistency mode is permitted for the target CA port.
disable An REC in asynchronous consistency mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous through mode for the copy transfer mode.
If omitted, the existing setting is not changed. This parameter can only be specified for the
ports that both of the following conditions apply to: the Advanced Copy license has been
registered and the port mode is RA mode or CA/RA auto mode.
enable An REC in asynchronous through mode is permitted for the target CA port.
disable An REC in asynchronous through mode is suppressed for the target CA port.
Optional. This parameter specifies the TFO transfer mode (transfer mode of the Storage Clus-
ter).
If omitted, the existing setting is not changed. This parameter can only be specified for the
ports that both of the following conditions apply to: the Storage Cluster license has been regis-
tered and the port mode is RA or CA/RA auto mode.
enable A Storage Cluster transfer is permitted for the target CA port.
disable A Storage Cluster transfer is suppressed for the target CA port.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
248
P2X0-1210-05ENZ0