Chapter 2 Status Display
2.1 Storage System Status > show status
show status
This command displays a summary of the system status. It will display if any components in the system are in
an error or warning condition. It does not indicate if host servers are able to access the system.
■
Syntax
show status
■
Parameters
No parameters.
■
Output
Summary status
■
Example(s)
The following example displays a summary of the system status:
CLI> show status
Summary Status
CLI> show status
Summary Status
CLI> show status
Summary Status
Summary of the system status.
Empty
The ETERNUS DX is not defined or installed.
Normal
The ETERNUS DX is in normal state.
Pinned Data PIN data exists in the ETERNUS DX.
Unused
An undefined component is installed in the ETERNUS DX.
Warning
A component that is the target for preventive maintenance exists in the ETERNUS
DX.
Maintenance Maintenance is currently being performed on the ETERNUS DX.
Error
A component with an error exists in the ETERNUS DX.
Loop Down The ETERNUS DX is in BackEnd Down state.
Not Ready
"Not Ready" is a status where an abnormality is detected at a power-off, and I/O
access from the host cannot be received.
Subsystem Down
The ETERNUS DX is not available.
Change Assigned CM
Hot expansion and recovery of the controller is required.
[Normal]
[Error]
[Warning]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
38
P2X0-1210-05ENZ0