Set Fc-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters

set fc-parameters

This command sets up the parameters to control each Fibre Channel (FC) host interface port. Host Affinity
Mode can be changed by using this command.
For a change of host port mode, refer to the "set host-port-mode" command.
■ Syntax
set fc-parameters -port {
[-host-affinity {enable | disable}] [-connect {loop | fabric}]
[-rate {auto|4g|8g|16g}]
[-loop-id-assign {auto-ascending | auto-descending | manual}]
loop_id
[-loop-id
[-host-response-number
[-reset-scope {initiator-lun | target-lun}] [-reserve-cancel {enable | disable}]
[-rec-line-no
[-rec-transfer-sync {enable|disable}]
[-rec-transfer-stack {enable|disable}]
[-rec-transfer-consistency {enable|disable}]
[-rec-transfer-through {enable|disable}]
[-tfo-transfer-mode {enable|disable}]
[-revert-wwn]
■ Parameter
-port
-host-affinity
xyz
|all }
] [-frame-size {512|1024|2048}]
host_response_number
rec_line_no
]
This parameter specifies the FC interface port number to be set up. Two or more parameters
can be specified by separating them with a comma (,).
Example: -port 000,110
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the FC port
number.
Example: "123" indicates CM#1-CA#2-Port#3
all All FC interface ports
Optional. This parameter specifies the Host Affinity Mode. If omitted, the existing setting is not
changed.
The host affinity is the security capability of the system against host servers. The access from
hosts can be limited by enabling Host Affinity Mode. If the RA mode or Initiator mode is being
set for the specified ports, this parameter cannot be specified.
enable Host Affinity Mode is enabled.
disable Host Affinity Mode is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| -host-response-name
226
host_response_name
]
29).
P2X0-1210-05ENZ0