Fujitsu Eternus DX100 S3 User Manual page 275

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create host-iscsi-name
-host-group-number
or
-host-group-name
-new-host-group-name
■ Example(s)
The following example registers the alias "HBA1" for the iSCSI host "iqn.1991-05.com.microsoft", and the
iSCSI ip address "10.111.10.1". The host response number #1 is also assigned:
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -ip 10.111.10.1 -name
HBA1 -host-response-number 1
The following example registers an iSCSI host to both of the HBAs that are in a single server. The iSCSI name
is the property of the server and is the same for both HBAs. Each HBA has a different IP address. The
following commands register "HBA11" and "HBA12" as the respective alias for each HBA. When two iSCSI
HBAs are used, the iSCSI names will also be different:
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -ip 10.1.0.1 -name HBA11
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -ip 10.1.1.1 -name HBA12
The following example registers the alias "HBA1" for the iSCSI host "iqn.1991-05.com.microsoft", and any IP
addresses are allowed by omitting the "-ip" parameter:
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -name HBA1
In addition to the above example, IP addresses with the same iSCSI name can be specified as a different
alias:
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -name HBA1
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -ip 10.1.0.1 -name HBA2
The following example registers the alias "HBA1" for the iSCSI host "iqn.1991-05.com.microsoft". The
registered host alias is added to host group "HG1":
CLI> create host-iscsi-name -iscsi-name iqn.1991-05.com.microsoft -ip-version ipv4 -name HBA1 -host-group-
name HG1
Optional. This parameter specifies the host group identifier. The "-host-group-number" or the
"-host-group-name" parameter must be specified. Only one host group can be specified at the
same time. For details, refer to
host_response_number
Host response number
host_response_name
Host response name
Optional. This parameter specifies a new host group name. Only one host group can be
specified at the same time. For details, refer to
new_host_group_name
New host group name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"1.2.17 Host Group Syntax" (page
"1.2.17 Host Group Syntax" (page
275
30).
30).
P2X0-1210-05ENZ0