Create Thin-Pro-Pool - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.3 Thin Provisioning Pool Management > create thin-pro-pool

create thin-pro-pool

This command creates a Thin Provisioning Pool with the specified Thin Provisioning Pool name, drive
attribute, reliability, encryption, and a RAID group. The Thin Provisioning Pool is formatted automatically after
it is created. When registering a hot spare, refer to the "set global-spare" or the "set dedicated-spare"
command.
■ Syntax
create thin-pro-pool -name
warning
[-warning
[-assigned-cm {0|1|auto}] [-encryption {enable|disable}]
[-stripe-depth { 64kb | 128kb | 256kb | 512kb | 1024kb }]
■ Parameter
-name
-attribute
-level
-warning
-attention
alias_name
attention
] [-attention
This parameter specifies the alias name of a Thin Provisioning Pool. Only one name can be
specified. For details, refer to
alias_name Thin Provisioning Pool name
This parameter specifies the drive attribute of a Thin Provisioning Pool.
online Online disks
nearline Nearline disks
ssd SSDs
sed SEDs
This parameter specifies the RAID level.
0 RAID0
1 RAID1
5 RAID5
6 RAID6
10 RAID1+0
Optional. This parameter specifies the warning level of the Thin Provisioning Pool. The settable
range is 5 – 99%. If this parameter is omitted, the default value (90%) is set. The warning level
range should be equal to or higher than the "-attention" setting range.
warning
Warning level of the Thin Provisioning Pool
Optional. This parameter specifies the attention level of the Thin Provisioning Pool. The
settable range is 5 – 80%. If this parameter is omitted, the default value (75%) is set. The
attention level range should be equal to or lower than the "-warning" setting range.
attention
Attention level of the Thin Provisioning Pool
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
-attribute {online|nearline|ssd|sed} -level {0|1|5|6|10}
] -rg-mode {auto|manual} [-capacity
"1.2.5 Alias Name Syntax" (page
183
capacity disks
] [-disks ]
23).
P2X0-1210-05ENZ0