Fujitsu Eternus DX100 S3 User Manual page 869

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
ED231
ED232
ED233
ED234
ED235
ED236
ED237
ED238
ED239
ED23A
ED23B
ED23C
ED23D
ED23E
ED23F
ED240
ED241
ED242
ED243
ED244
Distribution of the control domain failed.
Distribution of the control domain failed. Wait for a while and try again.
The storage is not in "Normal" state.
The ETERNUS DX status is not normal. Request your maintenance engineer to investigate the error.
The version is not normal.
The version is not normal.
A remote copy is running.
A remote copy is running. Wait for a while and try again.
Reclamation of Thin Provisioning Volume is in progress.
CFL cannot be performed due to a Reclamation factor.
Not all batteries are in "Full Charge" state.
CFL cannot be performed because the battery capacity is insufficient.
Controller Firmware is not registered.
The target module does not exist in the BUD.
CFL is not executed yet.
CFL is not executed yet.
Because the numbers of connections to the specified device reached the maximum number, it is not
possible to connect it. Please wait for a while.
The number of connections exceeds the maximum number.
The firmware distribution function between devices of the specified device doesn't have
interchangeability with this device.
The function levels do not match.
The firmware types do not match.
The firmware types do not match.
The error occurred by the communication with the specified device.
The model types do not match.
Powering off is being performed.
Powering off is being performed.
CFL is running.
CFL is running. Wait for a while and try again.
The firmware is being downloaded.
The firmware is being downloaded. Wait for a while and try again.
Gateway is not set though the specified device is set outside the subnet.
The gateway is not set for the specified device that is outside of the subnet.
Duplicated IP address between the specified device and used LAN port.
The IP addresses of the specified device and the LAN port that is used are duplicated.
The specified device is in the subnet of unused LAN port.
The specified device is in the subnet of an unused LAN port.
Duplicated IP address between the specified device and allowed IP of unused LAN port.
The IP addresses of the specified device and the LAN port that is not used are duplicated.
Group IDs of the specified storage and the current storage are different.
The group IDs of the specified ETERNUS DX and the current ETERNUS DX are different.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
869
P2X0-1210-05ENZ0