Set Host-Iscsi-Name - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-iscsi-name

set host-iscsi-name

This command changes the details of an existing iSCSI host.
■
Syntax
set host-iscsi-name {-host-number
[-alias-name
[-chap-user {
[-host-response-number
[-cmdsn-count {unlimited | 20 | 40 | 80 | 120 | 180}]
■
Parameter
-host-number
or
-host-name
-iscsi-name Optional. This parameter specifies the iSCSI name that corresponds to an HBA. Between 4 and
-alias-name Optional. This parameter specifies an alias to the iSCSI name that corresponds to the "-iscsi-
-ip-version
host_number
alias_name
] [-ip-version {ipv4|ipv6}] [-ip
chap_user | ""}]
host_response_number
This parameter specifies the identifier of the host whose details are to be changed. If only the
host response identifier is being set, then one or more identifiers can be specified at the same
time. If not, then only one host identifier can be specified. For details, refer to
Syntax" (page 27).
host_number
iSCSI host number
host_name
iSCSI host name
223 alphanumerical characters, including hyphens (-), dots (.), and colons (:), can be used. If
omitted, the existing setting is not changed. Only one name can be specified at the same
time.
iscsi_name
iSCSI name
name" parameter. A maximum of 31 alphanumeric characters can be used. Usable characters
are those given in the "1.2.2 Keywords and Parameters" (page 22)
Commas (,) cannot be used. If omitted, the existing setting is not changed. Only one name can
be specified at the same time.
This name is not used for control purposes. It is only handled as a comment corresponding to
the iSCSI name.
alias_name
Alias name which corresponds to the iSCSI host
Optional. This parameter specifies the format of the IP address after the setting change. If this
parameter is omitted, the existing setting is not changed. If this parameter is omitted and the
"-ip" parameter is specified, a parameter value that corresponds to the format of the IP address
that is specified for the "-ip" parameter is specified.
ipv4 IPv4 format
ipv6 IPv6 format
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_name
| -host-name
ip_address
] [-name
| -host-response-name
277
iscsi_name
} [-iscsi-name
name
]
host_response_name
]
"1.2.11 Host
of the document overview.
P2X0-1210-05ENZ0
]