Thin Provisioning Pool Eco-Mode Management - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.3 Thin Provisioning Pool Management
3.3.2

Thin Provisioning Pool Eco-mode Management

This section explains the commands that are related to the Eco-mode functions of a Thin Provisioning Pool.
They are only applicable when the Eco-mode is enabled using the "set eco-mode" command.
The commands described in this section are not supported in the ETERNUS DX200F.
The three steps involved in enabling the Eco-mode functions are as follows:
Procedure
1
Enable the Eco-mode.
2
Create an Eco-mode schedule.
3
Assign the Eco-mode schedule to Thin Provisioning Pools.
For the Eco-mode and Eco-mode schedule settings, refer to
■ Summary of Thin Provisioning Pool Eco-mode settings through CLI
Setting of the Thin Provisioning Pools (TPP) with Eco-mode using CLI are as follows:
Procedure
1
Assign the Eco-mode to a TPP.
To assign an Eco-mode schedule to TPP, use the "set eco-thin-pro-pool" command.
To check the Eco-mode schedule, use the "show eco-thin-pro-pool" command. An Eco-mode schedule
can be released from an assigned TPP by using the "release eco-thin-pro-pool" command.
"3.1.3 Eco-mode Management" (page
191
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
End of procedure
88).
End of procedure
P2X0-1210-05ENZ0