Set Led - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.4 Utility > set led

set led

This command turns the specified LED(s) either on or off.
■
Syntax
set led -target { ce | de | disk | svc0 | svc1 | opnl } [ -de
■ Parameter
-target
-de
-disks
-led
■
Example(s)
The following example turns on the LEDs of disk#1 and disk#2 in DE#1:
CLI> set led -target disk -disks 001,002 -led on
The following example turns on the LEDs of all the components in DE#1:
CLI> set led -target de -de 1 -led on
This parameter specifies which enclosure will have all of the LEDs turned on or off. When "-
target disks" is specified, the "-disks" parameter must also be specified.
ce All components in the controller enclosure
de All components in the drive enclosure
disk Only the specified disks
Optional. This parameter specifies which drive enclosure LED are turned on or off. Only one
drive enclosure can be set. For details, refer to
parameter must be specified when "de" is specified for the "-target" parameter.
enclosure_number
Drive enclosure number
Optional. This parameter specifies which disks LED are turned on or off. Multiple disks can be
specified at the same time. For details, refer to
must be specified when "disk" is specified for the "-target" parameter.
disks
Drive
This parameter specifies whether the specified LEDs are turned on or off.
on Turn on the LED
off Turn off the LED
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
enclosure_number
"1.2.3 Drive Enclosure Syntax" (page
"1.2.4 Drive Syntax" (page
713
disks
| -disks ] -led { on | off }
22). This
23). This parameter
P2X0-1210-05ENZ0