Debug Platform Vlan - Cisco Catalyst 3560-X Command Reference Manual

debug platform vlan

debug platform vlan
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-80
Downloaded from www.Manualslib.com
Use the debug platform vlan privileged EXEC command to enable debugging of the VLAN manager
software. Use the no form of this command to disable debugging.
debug platform vlan {errors | mvid | rpc}
no debug platform vlan {errors | mvid | rpc}
errors Display VLAN error debug messages.
mvid Display mapped VLAN ID allocations and free debug messages.
rpc Display remote procedure call (RPC) debug messages.
Debugging is disabled.
Privileged EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The undebug platform vlan command is the same as the no debug platform vlan command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command Description
show debugging Displays information about the types of debugging that are enabled.
manuals search engine
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02