Figure 61: Installing A Air Filter In An Ex6210 Switch - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation
168
Phillips (+) screwdriver, number 1
To install the air filter in an EX6210 switch (see
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis.
Ensure that you are holding the filter in the correct orientation for installation; the
2.
foam side must face the chassis.
Push the six captive screws, one in each corner of the filter faceplate and two in the
3.
middle, into the corresponding hole in the chassis. Ensure that each screw is properly
seated in the corresponding hole in the chassis.
Tighten the screws by turning them clockwise, using the Phillips (+) screwdriver.
4.
CAUTION: Do not overtighten the screws. Applying excessive force might
damage the screws or the filter.
All screws must be tight enough, for the filter to be securely installed in the chassis.

Figure 61: Installing a Air Filter in an EX6210 Switch

100-1 20V/2
00-24 0V-15
47-63 Hz A
100-1 20V/2
00-24 0V-15
47-63 Hz A
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK OK
STAN D BY
ON
INPU T
OUTP UT
OK FAIL
OK
Removing the Air Filter from an EX6210 Switch on page 226
Figure 61 on page
0
1
2
3
4
5
6
7
8
9
9
100-1 20V/2
00-24 0V-15
47-63 Hz A
100-1 20V/2
00-24 0V-15
A
47-63 Hz
STAN D BY
ON
INPU T
OUTP UT
OK FAIL
OK
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK OK
168):
Copyright © 2014, Juniper Networks, Inc.