Powering On An Ex6200 Switch; Figure 69: Connecting The Power Supply Cables To An Ex6200 Switch - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Powering On an EX6200 Switch

184
Flat washer
Locking
washer
Nut
Cable lug
Install the plastic cover over the DC input terminals, using the Phillips (+) screwdriver
8.
to tighten the screw (see
CAUTION: Do not overtighten the screws. Applying excessive force might
damage the screws or power supply.
Ensure that the power supply is fully inserted and secured in the chassis. See
9.
a DC Power Supply in an EX6200 Switch" on page
Repeat Steps 2 through
10.
Powering On an EX6200 Switch on page 184
DC Power Supply in an EX6200 Switch on page 49
DC Power Supply LEDs in an EX6200 Switch on page 52
Before you power on the switch, ensure that:
You have installed all required switch components.
You have installed the required number of power supplies to support redundant
operation for the switch configuration (see
EX6210 Switch" on page
You understand how to protect the switch from electrostatic damage. See
of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to power on the switch:
An electrostatic discharge (ESD) grounding strap.
An external management device such as a PC.
A cable to connect the external management device to the master Switch Fabric and
Routing Engine (SRE) module's console (CON) port or management (MGMT) port in
the switch.
DC input terminal
Figure 68 on page 182).
9 for the remaining power supplies.
"Calculating Power Requirements for an
113).
288.
"Installing
153.
"Prevention
Copyright © 2014, Juniper Networks, Inc.