Figure 85: Open And Closed Positions Of The Line Card Ejector Lever; Figure 86: Removing A Line Card - Juniper EX6210 Complete Hardware Manual

Copyright © 2014, Juniper Networks, Inc.

Figure 85: Open and Closed Positions of the Line Card Ejector Lever

Open
Grasp both the ejector levers and gently slide the line card halfway out of the chassis.
7.

Figure 86: Removing a Line Card

CAUTION: Do not lift the line card by holding the ejector levers on the
faceplate or the edge connectors. The levers cannot support the weight
of the line card. Lifting the line cards by the levers might bend them. Bent
levers prevent the line cards from being properly seated in the chassis.
CAUTION: Do not stack line cards on top of one another or on top of any
other component. Place each line card separately in the antistatic bag or
on the antistatic mat placed on a flat, stable surface.
CAUTION: Be prepared to support the full weight of the line card as you
slide it out of the chassis.
Chapter 13: Removing Switch Components
Closed
0
1
2
3
221