Installing An Sre Module In An Ex6210 Switch; Figure 51: Installing A Fan Tray In An Ex6210 Switch - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Installing an SRE Module in an EX6210 Switch

156

Figure 51: Installing a Fan Tray in an EX6210 Switch

Top
handle
Bottom
handle
Removing a Fan Tray from an EX6210 Switch on page 213
Cooling System and Airflow in an EX6210 Switch on page 54
You can install either one or two Switch Fabric and Routing Engine (SRE) modules in an
EX6210 switch. The SRE modules install horizontally in the front of the chassis in the
slots labeled and .
4 5
NOTE: We recommend that you install two SRE modules for redundancy. If
you install only one SRE module, we recommend that you install it in slot
CAUTION: Do not lift the SRE module by holding the ejector levers. The levers
cannot support the weight of the module. Lifting the modules by the levers
might bend the levers, and the bent levers will prevent the SRE module from
being properly seated in the chassis.
Copyright © 2014, Juniper Networks, Inc.
.
4