Figure 71: Connecting An Ex Series Switch To A Management Console Through - Juniper EX6210 Complete Hardware Manual

Copyright © 2014, Juniper Networks, Inc.
To connect the device to a management console (see
Figure 72 on page 188):
Connect one end of the Ethernet cable into the console port (labeled
1.
or CON1 ) on the device.
For the location of the
CON/CONSOLE
See EX2200 Switches Hardware Overview.
See Rear Panel of an EX3200 Switch.
See Rear Panel of an EX3300 Switch.
See Rear Panel of an EX4200 Switch.
See EX4300 Switches Hardware Overview
See Front Panel of an EX4500 Switch.
See EX4550 Switches Hardware Overview
See "Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch" on
page 26.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
Connect the other end of the Ethernet cable into the console server (see
2.
Figure 71 on page 187) or management console (see
To configure the device from the management console, see
an EX Series Switch (CLI Procedure)" on page 192
Series Switch (J-Web Procedure)" on page
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
Figure 71: Connecting an EX Series Switch to a Management Console
Through a Console Server
Chapter 10: Connecting the Switch
Figure 71 on page 187
port on different devices:
Figure 72 on page
"Connecting and Configuring
or "Connecting and Configuring an EX
195.
and
, ,
CON CONSOLE
188).
187