Figure 16: Line Card Leds On A 48-Port Poe+ Card In An Ex6200 Switch; Figure 17: Line Card Leds On A 48-Port Sfp Line Card In An Ex6200 Switch; Table 21: Status Leds On Line Cards For Ex6200 Switches - Juniper EX6210 Complete Hardware Manual

Table 21: Status LEDs on Line Cards for EX6200 Switches

LED Color
Green
ON
Yellow
Unlit
Green
ST
Yellow
Unlit
Green
PoE
NOTE: This LED is
Yellow
present only on
EX6200-48P line
Unlit
card
Related
Documentation
Copyright © 2014, Juniper Networks, Inc.

Figure 16: Line Card LEDs on a 48-Port PoE+ Card in an EX6200 Switch

PoE

Figure 17: Line Card LEDs on a 48-Port SFP Line Card in an EX6200 Switch

Table 21 on page 35 describes the status LEDs on line cards for the EX6200 switch, their
colors and state, and the status they indicate.
State and Description
The line card is enabled or online.
The line card is disabled or offline.
No power is being supplied to the line card.
On steadily—The line card is functioning normally.
Blinking—The line card is booting.
On steadily—There is a line card failure or alarm.
Blinking—The line card is in diagnostic mode.
The line card is disabled or offline.
On steadily—PoE on the line card is functioning normally.
On steadily—PoE is not functioning normally.
PoE is disabled on the line card.
48-Port RJ-45 Line Card in an EX6200 Switch on page 31
48-Port PoE+ Line Card in an EX6200 Switch on page 32
48-Port SFP Line Card in an EX6200 Switch on page 33
Chapter 2: Component Descriptions
35