Figure 35: Pallet Fastener - Juniper EX6210 Complete Hardware Manual

Copyright © 2014, Juniper Networks, Inc.
Open the four pallet fasteners near the bottom of the shipping box that attach the
3.
cardboard box to the wooden pallet. To open a pallet fastener, squeeze together the
two ridges ("fins") in the depression in the latch, then slide the pallet fastener out of
the cardboard box slot in which it is inserted. See

Figure 35: Pallet Fastener

Carefully slice open the tape that holds the top of the cardboard box closed and open
4.
the top of the box.
Remove the cardboard accessory box from the center of the foam padding.
5.
Remove the foam padding from the top of the box.
6.
Slide the cardboard box off the pallet.
7.
Remove the plastic cover from the switch chassis.
8.
Use a 7/16-in. or 11-mm open-end or socket wrench to remove the four sets of bracket
9.
bolts that secure the chassis to the shipping pallet (on the chassis side).
Use a 10-mm open-end or socket wrench to remove the four sets of bracket bolts
10.
that secure the chassis to the shipping pallet (on the pallet side).
Unpack the accessory box and lay out the contents so that they are ready for use.
11.
Verify that your order includes all appropriate parts. See
12.
List) for an EX6210 Switch" on page 130
Store the brackets and bolts inside the accessory box.
13.
Save the shipping box, pallet, and packing materials in case you need to move or ship
14.
the switch at a later time.
Chapter 8: Installing the Switch
Figure 35 on page
"Parts Inventory (Packing
.
129.
129