Removing The Power Cord Tray From A Rack Or Cabinet For An Ex6200 Switch; Figure 88: Removing The Air Filter From An Ex6210 Switch - Juniper EX6210 Complete Hardware Manual

Related
Documentation

Removing the Power Cord Tray from a Rack or Cabinet for an EX6200 Switch

Copyright © 2014, Juniper Networks, Inc.

Figure 88: Removing the Air Filter from an EX6210 Switch

100-1 20V/2
00-24 0V-15
A
47-63 Hz
100-1 20V/2
00-24 0V-15
A
47-63 Hz
STAN D BY
ON
INPU T OUTP UT
OK FAIL
OK
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK OK
Installing the Air Filter in an EX6210 Switch on page 167
Maintaining the Air Filter in an EX6200 Switch on page 236
You can remove the power cord tray from a rack or cabinet. (The remainder of this topic
uses "rack" to mean "rack or cabinet.")
Before you begin to remove the power cord tray:
Ensure no power cables are resting on or threaded through the power cord tray.
Remove the switch if the switch and power cord tray are installed on a two-post rack.
See "Removing an EX6210 Switch from a Rack or Cabinet" on page
Chapter 13: Removing Switch Components
0
1
2
3
4
5
6
7
8
9
9
100-1 20V/2
00-24 0V-15
47-63 Hz A
100-1 20V/2
00-24 0V-15
47-63 Hz A
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK
OK
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK
OK
202.
227