Figure 58: Installing A Line Card - Juniper EX6210 Complete Hardware Manual

Copyright © 2014, Juniper Networks, Inc.
CAUTION: Before you slide the line card into the slot on the switch chassis,
ensure the line card is aligned correctly. Misalignment might cause the
pins to bend, making the line card unusable.
Lift the line card, and position it in the chassis with the faceplate facing you and the
6.
sides of the line card aligned with the guides in the line card slot on the switch chassis.
Make sure the levers stay in the open position (see
7.
slide the line card fully into the slot using both hands.
Grasp the ejector levers on the line card and push them inward simultaneously until
8.
the ejectors are perpendicular to the faceplate of the line card (see
Figure 57 on page 162) and the line card is fully seated (see

Figure 58: Installing a Line Card

Tighten the captive screws on the faceplate of the line card by using the screwdriver.
9.
CAUTION: Do not overtighten the screws. Applying excessive force might
damage the screws or line card.
Verify that the ON LED starts blinking in green. When the
10.
card is ready for use.
CAUTION: After the
before installing another line card or removing a line card.
Verify that the SRE module filler panel is installed in slots 4 or 5, if a line card is installed
11.
in either of these slots, to ensure proper airflow in the chassis.
You can verify that the line card is functioning correctly by issuing the
and
show chassis fpc pic-status
Chapter 9: Installing Switch Components
Figure 57 on page
0
1
2
3
LED is lit steadily, wait for at least 30 seconds
ON
commands.
162) and gently
Figure 58 on page 163).
ON LED is lit steadily, the line
show chassis fpc
163