Installing The Power Cord Tray In A Rack Or Cabinet For An Ex6200 Switch; Figure 38: Adjustable Mounting Brackets Installed In A Four-Post Rack - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Installing the Power Cord Tray in a Rack or Cabinet for an EX6200 Switch

136

Figure 38: Adjustable Mounting Brackets Installed in a Four-Post Rack

(EX6210 Switch)
(Optional)
Adjustable
bracket
Mounting an EX6210 Switch on a Rack or Cabinet Using a Mechanical Lift on page 141
Mounting an EX6210 Switch on a Rack or Cabinet Without Using a Mechanical Lift on
page 143
Mounting an EX6210 Switch on a Rack or Cabinet on page 138
NOTE: The power cord tray is optional for four-post and two-post rack or
cabinet installations of EX6200 switches.
The power cord tray does not ship with the EX6200 switches. You can purchase it
separately.
The power cord tray provides a place to organize and tie down the power cords for the
power supplies. It also provides support for the front of the EX6210 chassis during
installation of the switch in a two-post rack. The front edge of the chassis rests on the
upper edge (lip) of the power cord tray.
The power cord tray uses 1 U of rack space (the remainder of this topic uses "rack" to
mean "rack or cabinet" ) , so the total space occupied by an EX6210 switch chassis and
power cord tray is 15 U.
Ensure that you have the following tools and parts available to install the power cord
tray:
A Phillips (+) screwdriver, number 1, 2, or 3, depending on the size of your rack mounting
screws
4 mounting screws appropriate for your rack to attach the power cord tray to the rack
Front-mounting
bracket
Copyright © 2014, Juniper Networks, Inc.