Juniper EX6210 Complete Hardware Manual page 43

Table 11: LCD Panel Menu Options for the EX6200 Switch (continued)
Menu Description
Maintenance The Maintenance menu has the following options:
SYSTEM HALT?—Choose one of the following:
Press
Enter
In a non-redundant configuration (one SRE module installed) switch, the master SRE module will be
gracefully halted but not powered off. Press
to bring the switch up.
In a redundant configuration (two SRE modules installed), the backup SRE module takes over mastership
when the master SRE module is halted. To completely halt the switch, use the
other-routing-engine
Press
Enter
See "EX6210 Switch Configurations" on page 7
Press
Menu
SYSTEM REBOOT?—Choose one of the following:
Press
Enter
Press
Menu
LOAD RESCUE?—Choose one of the following:
Press Enter
rollback.
Press
Menu
FACTORY DEFAULT?—Choose one of the following:
Press
Enter
restoration. The LCD panel flashes a success or failure message and returns to the Idle menu.
Press Menu
ENTER EZSETUP?—Choose one of the following:
Press
Enter
EZSetup configures DHCP and enables the J-Web user interface on the switch. The LCD panel flashes a
success or failure message for approximately 10 seconds and returns to the Idle menu.
Press
Menu
NOTE: You can use the EZSetup option only if the switch is in the factory default configuration. For information
about EZSetup, see
EXIT MAINT MENU?—Choose one of the following:
Press
Enter
Press
Menu
If you do not want users to use Maintenance menu options, disable the entire menu or individual menu options.
See Configuring the LCD Panel on EX Series Switches (CLI Procedure).
Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
to halt the master SRE module in an EX6200 switch. Press
CLI command to halt the backup SRE module before halting the master SRE module.
on your management device or power cycle the switch to bring the switch up.
to go to the next option in the Maintenance menu.
to reboot the master SRE. Press
to go to the next option in the Maintenance menu.
to roll back the switch to the previous valid configuration. Press
to go to the next option in the Maintenance menu.
to restore the switch to the factory default configuration. Press
to go to the next option in the Maintenance menu.
to launch EZSetup. Press
Enter
to go to the next option in the Maintenance menu.
"Connecting and Configuring an EX Series Switch (J-Web Procedure)" on page
to exit the Maintenance menu.
to return to the SYSTEM HALT option.
Chassis Status LEDs in an EX6200 Switch on page 24
Field-Replaceable Units in an EX6210 Switch on page 25
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 192
Enter
on your management device or power cycle the switch
Enter
for information on configuration types.
again to confirm the reboot.
Enter
again to confirm the launch.
Chapter 2: Component Descriptions
again to confirm the halt.
request system halt
Enter again to confirm the
again to confirm the
Enter
195.
23