Unpacking An Ex6200 Line Card; Figure 54: Installing An Sre Module In An Ex6210 Switch - Juniper EX6210 Complete Hardware Manual

Related
Documentation

Unpacking an EX6200 Line Card

Copyright © 2014, Juniper Networks, Inc.

Figure 54: Installing an SRE Module in an EX6210 Switch

Removing an SRE Module from an EX6200 Switch on page 217
Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch on page 26
The line cards for EX6200 switches are rigid sheet-metal structures that house the line
card components including network ports. The line cards are shipped in a cardboard
carton, secured with foam packing material.
CAUTION: The line cards are maximally protected inside the shipping carton.
Do not unpack the line cards until you are ready to install them in the switch
chassis.
Before you unpack a line card:
Ensure that you have taken the necessary precautions to prevent ESD damage (see
"Prevention of Electrostatic Discharge Damage" on page
Ensure that you know how to handle and store the line card. (see
Line Cards in EX6200 and EX8200 Switches" on page
To unpack a line card (see
Move the shipping carton to a staging area as close to the installation site as possible.
1.
Position the carton so that the arrows are pointing up.
2.
Open the top flaps on the shipping carton.
3.
Pull out the packing material, which holds the line card in place.
4.
Figure 55 on page 160):
Chapter 9: Installing Switch Components
0
1
2
3
4
5
6
288).
"Handling and Storing
231).
159