Figure 45: Installing An Ex6210 Switch In A Two-Post Rack; Figure 46: Installing An Ex6210 Switch In A Four-Post Rack - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
146
Visually inspect the alignment of the chassis. If the chassis is installed properly in the
6.
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the switch is level.
After ensuring that the switch is aligned properly, tighten the screws.
7.

Figure 45: Installing an EX6210 Switch in a Two-Post Rack

Two-post rack

Figure 46: Installing an EX6210 Switch in a Four-Post Rack

(Optional)
Adjustable
bracket
After you install the mounting screws and securely bolt the chassis to the rack, reinstall
the components in the chassis. See:
Installing an SRE Module in an EX6210 Switch on page 156
Installing a Line Card in an EX6200 Switch on page 160
Installing a Fan Tray in an EX6210 Switch on page 154
Front-mounting
bracket
Front-mounting
bracket
Copyright © 2014, Juniper Networks, Inc.