Ac Power Supply Power Cord Retainer; Figure 21: Power Cord Retainer For A 2500 W Ac Power Supply - Juniper EX6210 Complete Hardware Manual

AC Power Supply Power Cord Retainer

Copyright © 2014, Juniper Networks, Inc.
cord. This separate protective earthing terminal must be permanently
connected to earth ground.
NOTE: All switch configurations of EX6200 switches are shipped with one
power supply. Cover panels are installed over the remaining three power
supply slots. Additional power supplies can be added to the different switch
configurations as necessary.
For details about different switch configurations, see
Configurations" on page 7
This section describes the power cord retainers for the 2500 W and 5000 W AC power
supplies:
2500 W AC power supply—Each 2500 W AC power supply ships with a power cord
retainer that holds the power cord in place. See
retainer has a clip and an adjustment nut. The L-shaped ends of the clip hook into the
bracket holes on the top and bottom of the AC appliance inlet on the faceplate. The
adjustment nut holds the power cord in the correct position. For instructions on installing
the power cord retainer, see

Figure 21: Power Cord Retainer for a 2500 W AC Power Supply

10 0-1 20 V/2
00 -24 0V -15
47 -63 Hz
ST AN D BY
INP UT
OU TP UT
OK
OK
Adjustment
nut Retainer clip
5000 W AC power supply—Each 5000 W AC power supply ships with two power cord
retainers that hold the power cords in place. Each power cord retainer has a clip and an
adjustment nut. The L-shaped ends of the clip hook into the bracket holes on the sides
of the AC appliance inlet on the faceplate. The adjustment nut holds the power cord in
the correct position. For instructions on installing the power cord retainer, see
AC Power to an EX6200 Switch" on page
.
Figure 21 on page
"Connecting AC Power to an EX6200 Switch" on page
A
ON
FA IL
177.
Chapter 2: Component Descriptions
"EX6210 Switch
41. The power cord
177.
"Connecting
41