Figure 82: Open And Closed Position Of The Sre Module Ejector Lever - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
218
To remove an SRE module from the switch (see
Take the SRE module offline. See
1.
Switch" on page 215.
Attach the antistatic discharge (ESD) grounding strap to your bare wrist and connect
2.
the strap to one of the ESD points on the chassis.
Place the antistatic bag or antistatic mat on a flat, stable surface.
3.
Unscrew the screws on each side of the SRE module by turning them counterclockwise
4.
using the screwdriver until they are lose.
Pull both the ejector levers outwards, away from the faceplate of the SRE module,
5.
until they go no further. This causes the SRE module to unseat and slide out of the
chassis slightly. Figure 82 on page 218
ejector levers.

Figure 82: Open and Closed Position of the SRE Module Ejector Lever

Open
Grasp both the ejector levers and pull the SRE module out to about halfway.
6.
Taking care not to touch the leads, pins, or solder connections, place one hand
7.
underneath the SRE module to support it and slide it completely out of the chassis.
Figure 83 on page
"Taking the SRE Module Offline in an EX6200
shows the open position of the SRE module
Closed
Copyright © 2014, Juniper Networks, Inc.
219):