Figure 53: Sre Module Cover Panel - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
158

Figure 53: SRE Module Cover Panel

SRE module
filler panel
SRE module
cover panel
Line card
cover panel
Carefully align the sides of the SRE module with the guides inside the chassis.
5.
CAUTION: You must install the SRE module in the slots labeled
Installing the SRE module in any other slot will damage the module.
Ensuring that the SRE module is correctly aligned, carefully slide it into the chassis
6.
until you feel resistance.
Push both the ejector levers towards the faceplate of the SRE module until the levers
7.
are parallel to the faceplate and are fully engaged.
closed position of the ejector lever.
NOTE: Ensure that the SRE module is fully seated in the chassis. It must
be fully seated in order for it to be powered up and function correctly.
Tighten the captive screws, one on each side of the SRE module, by turning them
8.
clockwise using the Phillips (+) screwdriver.
CAUTION: Do not overtighten the screws. Applying excessive force might
damage the screws or module.
Verify that the SRE module is installed correctly and functioning normally by checking
9.
the LEDs on the faceplate of the SRE module.
Line card
cover panels
4
Figure 52 on page 157 shows the
Copyright © 2014, Juniper Networks, Inc.
or 5 .